Rss Feed
Tweeter button
Facebook button
Linkedin button


SUBMIT FREE ARTICLES   | ABOUT | CONTACT | SITEMAP |

domains

Learn How To Accomplish Quick Sash Window Repairs That Are Effective

May 16, 2013 | Author: | Posted in MOTIVATIONAL

Anyone that owns a historic home will confess to having dealt with the annoyance of the antique sliding windows not functioning properly. Most see the removal of these units as a good decision, albeit very costly. Nonetheless one should consider the fact that many are over 120 years old and may just need sash window repairs in order to function again.

Frames were hand crafted and are generally extremely heavy which is why if regularly maintenance is not carried out problems may occur. Despite many preconceived ideas repairs can be carried out quite easily. Typically these windows are made up of two panels, called a sash which slide individually into position.

These panels move up and down the inside of a boxed framed by means of a counter balance theory. Besides the problems with movement many tend to allow noise and breezes into the home. This results from the way the frame is designed to keep the working mechanisms of the window and is quick to repair.

There are a few steps that need to be taken to repair or maintain one of these “old timers”. Firstly a person will need to dismantle the entire window. The lower sash is held in place by two thin strips of wood which can be gently removed using a chisel and rubber hammer. On removal of this wood strip on either side the bottom part can be removed.

Sometimes the sash cord may still be attached, simply cut it but be sure to hold the little weight firmly to stop it from slipping in the bottom opening of the frame. Removing the upper sashes is somewhat similar and once again a vertical strip of wood is all that holds it in place. It is suggested that one replace all the cords at one time to ensure that this does not have to be redone in a few months time again.

The frame itself has a lower compartment or house in which the working mechanisms of the system are stored; removal of another type of panel will expose the pockets. However if these have been idiotically screwed into place then the probability is that one will spend quite some time trying to pry it loose. But when removed it will expose a single very long weight inside the pocket.

Here individuals will also find another main component; the pulley which depending on age will be made from brass, iron or copper. Part of the poor operation can be evident here especially if the mechanism is covered in grime. Thoroughly cleaning all the dirt off followed by the application of some oil may get it working perfectly again. On the other hand if it turns out to be broken there are durable plastic versions available at most hardware stores.

Next a person will have to tackle the replacement of the cords, these are available at most hardware stores but be sure to purchase the thicker 8 stringed version. Cut two extra long pieces of cording and guide each one into the top section of the pulleys, having the ends hang freely out the bottom of the frame.

Thread the loose end into the long weights from the top out through the side and then tie a secure knot in place to stop it from pulling back through the hole. Cut the extra cord from the knots and use the cord to pull the long weight back inside the pocket. Close the compartment up and then tie the other end of the cording onto the sash. To make this easier it is best that the window sashes are angled while both ends are aligned by drawing the weight up into the pulley for accuracy.

Do the above steps for both the top and bottom sashes to ensure that both operate smoothly. Tack the wooden “beads” into place to secure the window and that is a Sash window repair completed. To seal any draughts a patented brush pile system can be installed as well.

In general, if a person carries out sash window repairs in this manner every twelve to fifteen years, they are guaranteed to last for the next 100 years or so. Before starting any work, make sure you know exactly what you are doing. There are many experts out there who specialize in this work, so consider giving them a call to ask for advice and to find out how they recommend you get on with the job.

If you want to locate dependable sash window draught proofing London homeowners should look on the Web. See images and models of Wooden windows London residents need right here.

email

Author:

This author has published 1 articles so far. More info about the author is coming soon.

Leave a Reply

You must be logged in to post a comment.